POLYESTER
Project 1
In 2006, I needed 3 months
to realise my rear bumper.
Because I took that long I didn't had the time to make a mould.
So after some cracks in my rear bumper, due to some holes in the raod
(I didn't noticed), it was finally time to make time to make the mould
... in 2007 !! =)
Preparing
the bumper
90% gelcoat
100 % gelcoat
Polying
the mold
The mold
and bumper
The mold
Gelcoat
in the mold
Poly in
the mold
The mold
and my new bumper
The new
bumper on the car
Cut the
LPG holder out the yellow bumper
Gelcoat
in the yellow part
The mold
Gelcoat
on the mold
polyester
on the mold
Left; The
mold - Right: the poly part
Polying
the part
Result
Sanding
the bumper
In spray
filler
In spray
filler
On the car
04
februari - 18 March 2007
